VDC-MC08SL is a miniature camera module built around a 1/2.9 inch SONY IMX323 sensor and an FH8536H image processor. Active pixels are 1920(H) x 1080(V), at 25 fps or 30 fps, in PAL or NTSC formats. Automatic gain control, wide dynamic range, 2D/3D noise reduction and auto white balance work behind the sensor, giving 0.01 Lux at F1.2 with AGC on, a shutter of 1/25 s to 1/100,000 s, 85 dB dynamic range and a signal-to-noise ratio above 58 dB. Video leaves over coax as AHD, CVI, TVI or CVBS, so one module follows whichever format the recorder supports, without separate stock per standard. Power input is DC 3.3V (+/-10%), the body is 12 mm x 12 mm x 6 mm, and lenses are selectable from 3.7 mm, 3.6 mm, 6 mm, 8 mm, 12 mm and 16 mm, in normal or pinhole builds.

Its small size lets the module hide inside a housing or trim piece with only the lens exposed, a pinhole build reducing the visible opening and a normal lens easier to aim. The lens faces the target and focal length sets angle and reach: 3.7 mm and 3.6 mm cover a wide area close by, 8 mm, 12 mm and 16 mm a narrower view at longer distance. Before connecting, confirm the supply reaching the module is DC 3.3V and match the recorder input format to the module output, since a mismatch shows no picture. Commission by checking picture stability, then low-light noise and the handling of bright and dark areas together, where wide dynamic range and noise reduction matter; if the image misbehaves, recheck format and supply before focal length. Selection covers sensor size and pixel count, the low-light figure, the output formats and whether the body fits, with the site kept between -30 C and +60 C at 95% humidity or below and room left for cabling and heat.